Bonjour,
Associe a vgscan, il est indique:
You may need to run the vgscan command manually when you change your hardware configuration, causing new devices to be visible to the system that were not present at system bootup. This may be necessary, for example, when you add new disks to the system on a SAN or hotplug a new disk that has been labeled as a physical volume.
Est-ce qu'il n'y a pas moyen de faire cela automatiquement?
Merci.
===========================================================================
Patrick DUPRÉ | | email: pdupre@???
Laboratoire de Physico-Chimie de l'Atmosphère | |
Université du Littoral-Côte d'Opale | |
Tel. (33)-(0)3 28 23 76 12 | | Fax: 03 28 65 82 44
189A, avenue Maurice Schumann | | 59140 Dunkerque, France
===========================================================================
