J'avais passé il y a qq temps une question à propos d'un message
d'origine non déterminée. Je n'avais pas obtenu de réponse adéquate.
Voici la réponse qui m'est fournie par le commande dmesg
maintenant que mon usbmount est finalement opérationnel :
On distingue bien les 3 étapes successives de ce test :
Connecteur USB vide
Memory stick connecté
Memory stick déconnecté
[...]
Device not ready. Make sure there is a disc in the drive.
Device not ready. Make sure there is a disc in the drive.
Device not ready. Make sure there is a disc in the drive.
Device not ready. Make sure there is a disc in the drive.
Device not ready. Make sure there is a disc in the drive.
Device not ready. Make sure there is a disc in the drive.
usb 5-7: new high speed USB device using address 6
scsi5 : SCSI emulation for USB Mass Storage devices
Vendor: Model: USB DISK 20X Rev: PMAP
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sdb: 243712 512-byte hdwr sectors (125 MB)
sdb: assuming Write Enabled
sdb: assuming drive cache: write through
/dev/scsi/host5/bus0/target0/lun0: p1
Attached scsi removable disk sdb at scsi5, channel 0, id 0, lun 0
Attached scsi generic sg3 at scsi5, channel 0, id 0, lun 0, type 0
USB Mass Storage device found at 6
Device not ready. Make sure there is a disc in the drive.
Device not ready. Make sure there is a disc in the drive.
(instant de la déconnexion)
usb 5-7: USB disconnect, address 6
Device not ready. Make sure there is a disc in the drive.
Device not ready. Make sure there is a disc in the drive.
[...]
D'après moi c'est une aberration que dmsg soit pollué en permanence en
l'absence du memory stick. Mais peut-être faut-il apprendre à vivre avec.
--
"Robert L.E.Billon" <rleb07@???>
http://rleb07.free.fr &
http://f3wm.free.fr
